Conductivity sensor technology

The LDL100 conductive sensor

The LDL100, like other directly measuring conductivity sensors, has two metallic electrodes. The difference in our design is that the sensor housing and metal tube serve as the first electrode and the metal tip of the sensor serves as the second electrode.

Voltage is applied between the sensor tip and the housing screw connection and the current flow is measured.

Note: Given the design of its electrodes, the LDL is not recommended for use in plastic pipes.

The LDL101 conductive sensor

Unlike the LDL100, the LDL101 does not use its housing as electrode, but has two ring-shaped electrodes set into one another. The voltage is applied between the inner and outer electrode and the current flow is measured there.

It is important to note that in contrast to the LDL100, the LDL101 has a fixed cell constant. With the internally used software, different cell constants can be mapped in order to achieve the best resolution over the entire measuring range at all times. So the LDL101 offers functions in one device other sensors require different versions for.

An inductive conductivity sensor consists of two metal coils wound with wire and enclosed in a plastic body (ifm uses PEEK for this purpose). The first coil (transmitter coil) generates an electrical voltage in the liquid. Depending on the conductivity of the medium, an alternating current is generated. The latter generates an alternating magnetic field in the second coil (receiving coil) that is proportional to the conductivity of the medium.

Inductive conductivity measurement has several advantages:

• High resistance to corrosion thanks to the PEEK tip.
• Insensitivity to solids in the medium as long as the measuring channel is not clogged.

Did you know?

A common problem with injection-moulded, long PEEK tips is that they tend to break off. This is due to the stress caused by temperature and pressure fluctuations that occur especially in CIP applications.
Turned from one piece, the tip allows the PEEK material to expand evenly with temperature changes, distributing pressure more evenly across the shaft and preventing potential stress points. General machine availability is maintained.

The conductivity of a material is particularly dependent on temperature approximately 1...5% per °C. All conductivity sensors have a built-in temperature measurement to compensate for temperature changes in the medium.

The graph is intended to show the difference between compensated and uncompensated conductivity. Without compensation (blue line), the conductivity increases or decreases based on the temperature, i.e. the conductivity no longer remains constant although the medium is still the same. When using compensation (orange line), a constant and repeatable measurement is provided. This renders the measured values comparable at different times. More information on temperature compensation and how to adjust it can be found in the section on calibration.

A free factory certificate is available for each ifm conductivity sensor. It is generated directly in production and assigned to the serial number.The sensor passes through different calibration stations, each with different temperatures and conductivities. During final calibration, the sensor is compared with a reference sensor. All this information can be taken from the factory certificate.
Download the factory certificate free of charge from our website. Make sure that you have the serial number of the sensor at hand to enter it.

Field calibration

ifm sensors arrive at your premises ready for use. However, you can still adjust the sensor to specific media or reference temperatures on site. For this purpose, the two parameters "Calibration gain CGA" and "Temperature compensation T.cmp" can be set so that the sensor is adjusted to a known reference medium.

Calibration gain [CGA]: aligns the measurement curve of the sensor to the known value of the reference medium. It is possible to set a value between 80 to 120 %. For the calculation, the known value is divided by the measured value.

Temperature compensation [T.cmp]: extent to which a temperature deviation from the reference temperature (usually 25 °C) causes a change in conductivity.

• The compensation can be set freely between 0 and 5 %/K.
• The temperature compensation is either provided in the data sheet of the medium (for water-based media the standard is 2%) or determined via a straight line equation by measuring the same medium at 2 temperatures.

Adjusting CGA and T.cmp can lead to higher accuracy, but in most cases is not necessary.